369271

MOTEC / JRR SUBARU STI 04 07 M150 PNP KIT

From
$92.69
Learn More
Check Store Availability

We don't have enough stock on hand.

Adding to cart… The item has been added
Added to Cart




JRR Subaru STi 2004 - 2007 M150 PNP Kit




  • This full standalone kit replaces the stock ECU and provides a powerful tuning solution. The M150 kit plugs right in to your Subaru STi and includes a start up calibration customized to your setup




  • This kit is available for Subaru STi from 2004 to 2007. If you have a non-USDM model, please let us know when you order so we can determine which PNP harness you need.



  • The included firmware suits Subaru EJ 4 cylinder engines with single or dual AVCS, 36-2-2-2 crank trigger pattern, 4-1 inlet cam pattern, 2 tooth exhaust cam pattern (dual AVCS) and no separate sync sensor




  • Supports the OE DCCD active center differential ECU, or the DCCD can be connected to the M1 ECU via a optional PNP pigtail which allows full mapping of the DCCD system from within M1 Tune




  • Supports the factory cruise control




  • Flex fuel control - adjust fuel, timing, boost, cold start and more based upon ethanol content




  • Supports running two separate fuel systems - each running a different type of fuel




  • Nitrous control - various parameters supplied to control nitrous. Includes nitrous bottle heater relay control based on nitrous pressure




  • CO2/wastegate pressure control - controls a fill/bleed solenoid setup to control wastegate pressure




  • Water injection control - with failsafe for boost/timing/fuel based on pressure sensor feedback




  • Air bypass anti-lag control - using pneumatic valve with solenoids or servo valve




  • Turbo shaft speed limiting




  • Supports the use of third party lambda controllers with 0-5v output




  • Supports momentary buttons




  • Supports direct input from a MoTeC/Racegrade CAN keypad




  • Like anything, the MoTeC M1 requires knowledge and experience to gain the best results. While we are happy to answer technical questions, purchase of this M1 kit does not come with unlimited tuning support. We can quote tuning for your particular setup, refer you to someone in your area, or if you prefer to do it yourself (and lack the experience) then we can also quote training




  • This ECU kit is for closed course competition vehicles only. It does not meet federal emissions requirements.



  • THIS ITEM IS SPECIAL ORDER AND IS BUILT TO ORDER!





USD : 92.69

WASHING INSTRUCTIONS:

Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.

Reviews