358303

T1 RACE T1 CBR Wire Harness for the M&W Pro 14

From
$92.69
Learn More
Check Store Availability

We don't have enough stock on hand.

Adding to cart… The item has been added
Added to Cart

T1 M&W Pro 14 wire harness for use with CBR coils


Coils NOT included.


This is the same harness we use in our Pro 14 CBR kit and our Ultimate Ignition kit. We start with multi conductor tefzel shielded wire for all signal wires to minimize the possibility of RF noise interference. The harness is assembled with all new connectors and includes an 8 pin Deutsch connector for the coil sub harness. Loomed with DR25 shrink and finished off with a boot for the CDI connector, this harness is ready to plug in and go with minimal wiring involved to finish it off (trigger wires must be wired into your ecu).


USD : 92.69

WASHING INSTRUCTIONS:

Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.

Reviews