The use of factory exhaust manifold bolts and studs, especially with an aftermarket header/turbo system, can result in stripped or broken bolts and inadequate clamping force, resulting in leaks. This stud kit looks great and will allow you to properly clamp the exhaust manifold to the cylinder head without experiencing sealing problems, stud/nut failure, or ugly and troublesome rust and corrosion. Titanium is ~45% lighter, stronger, and will not corrode like your stock steel bolts or studs.
SpeedFactory Titanium Stud Kits are made of high quality Ti 6Al-4V and incorporate a hex key tip that allows them to be easily installed using an Allen wrench. Titanium 6-point nuts and washers are included.
Each M8 stud/washer/nut assembly weighs only 11.5g!
These kits include the following:
(10) M8 x 1.25mm x 45mm titanium studs
(10) 6-point M8x1.25mm titanium nuts
(10) M8 titanium washers
Available in standard or burnt titanium finish.
USD : 51.75
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
