SpeedFactory Universal Intake / Exhaust Manifold Titanium Stud Set
This kit includes (10) M8 x 1.25mm x 55/65mm Ti 6Al-4V studs, nuts, and washers.
Use of factory exhaust manifold bolts and studs, especially with an aftermarket intake manifold or header/turbo system, can result in stripped or broken bolts and inadequate clamping force, resulting in leaks. Our studs look great and will allow you to properly clamp the intake or exhaust manifold to the cylinder head without experiencing sealing problems, stud/nut failure, or ugly and troublesome rust and corrosion.
SpeedFactory Titanium studs are made of Ti 6Al-4V and incorporate a 3mm hex key tip that allows them to be easily installed using an Allen wrench. A Titanium 10mm 12-point nut and washer are included.
Titanium is ~45% lighter, stronger, and will not corrode like your stock steel bolts or studs! Each stud/washer/nut assembly weighs only 12g!
Available in raw or burnt titanium finish.
-Universal M8x1.25mm thread pitch fits many popular applications for intake and exhaust manifolds.
-Fits all Honda/ Acura DOHC B Series (B16, B18, B20), all D15, D16, F20B, F20C, F22C, H22, H23, and more.
USD : 51.75
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
