Congratulations!! You have found the highest-flowing and most powerful LT1/LT4 cylinder head on the market. LME pulled these castings straight from Edelbrock's foundry right here in the USA and machined them to perfection.
- THICK CASTING - FREEDOM TO DESIGN PORTS FOR BIG HP
- REVISED EXH PLACEMENT - STRAIGHTEN EXH- FACTORY HEADS HAVE A TWIST- EXH CFM OVER 300
- THICKER DECK FOR IMPROVED HEAD GASKET SEALING
- REVISED VALVE/GUIDE LOCATIONS-OPTIMIZED FOR HIGH HP, HIGH BOOST
- MANUFACTURING IN-HOUSE- GIVES US QUALITY CONTROL FROM START TO FINISH
- HIGH-QUALITY CHE SEATS AND GUIDES
- FREEDOM TO REVISE DESIGN TO ADAPT TO DIFFERENT APPLICATIONS
- FITS BOTH LT1 AND LT4 MANIFOLD BOLT PATTERNS
- INTAKE FLANGE HAS BEEN THICKENED TO RAISE MANIFOLD-WHICH ALSO RAISES THE PORT
- SPRING POCKETS RAISED FOR THICKER ROOF, RAISED PORTS, AND LARGER POSSIBILITY OF SPRING
- CAN USE FACTORY ROCKER BUT IS ALSO EASILY ADAPTABLE TO THE MOST ADVANCED ROCKER SYSTEMS
- MACHINED FOR LARGE DIA PUSHRODS
- SIX BOLT ARRANGEMENT
- OVERALL MUCH BETTER BREATHING
- CAN BE CONFIGURED TO RUN ON DIRECT OR PORT INJECTION - OR BOTH
- INTERLOCKING VALVE SEAT CONFIGURATION FOR IMPROVED SEAT INTEGRITY
- USA MADE CASTING - EDELBROCK- PIONEER SINCE 1930'S
USD : 92.69
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
