We have had numerous requests to offer the economy layered adjustable chassis bracket in a dedicated "Low Prep" style geometry. For those that are wanting the advantages of an unequal length 4 link with unrivaled adjustment and economy of cost, we have a the perfect solution for you!
The bracket assembly is made of 4130N making it a great choice for longevity and durability. The shorter upper bar allows the car separate quickly on the launch like a stock suspension radial car, while still keeping the versatility and strength of a traditional 4 link. The unequal length 4 link brackets were designed for drag radial cars. Through alot of testing and racing with the bracket design discovered the unequal length geometry worked really well on no prep to moderate prep on any small tire, slick or radial.
The 1/4 bolt serves as the adjustment indicator for a given heim hole choice, adjusting through the sweep in 1/8" increments up to 5/8" before needing to adjust to the next heim hole. Because the upper adjustments are on an angle, the upper 4 link bar stays at the same approximate nominal length through the adjustment sweep making the adjustment variable more consistent.
Specs:
- 4130N material
- 1/4" main brackets layered x 3 for overall width of 3/4"
- 1/4" heim brackets
- 1/8" doublers
- 12pt grade 9 hardware
- 1 5/8" Lower Tube notch
- 1 5/8" / 1 1/4" Cross bare holes
- 1/2" Holes on 5/8" spacing
- 1/8" adjustment capability
Adjustable 4 Link Chassis Brackets (Economy) kit will include:
- 2ea 1/4” 4 link chassis inner brackets
- 4ea 1/4" 4 link chassis outer brackets
- 4ea 1/4" 4 link chassis upper heim brackets
- 4ea 1/8" 4 link chassis upper heim bracket doublers
- 4ea 1/4" 4 link chassis lower heim brackets
- 4ea 1/8" 4 link chassis lower heim bracket doublers
- 12ea 3/8-24 12 point bolts, NAS washers, and nylon jam nuts
- 4ea 1/4-28 12 point bolts, NAS washers, and nylon jam nuts
***Requires TIG welding. The perimeter of the main bracket layers has an 1/8" step to allow for a good welding surface. Additionally, the lightening pockets serve as a perimeter for additional welding for maximum bonding and strength***
***Recommend welding no more than 2” at a time alternating ends and sides to minimize heat and distortion. Clamp to a flat surface is best ***
USD : 92.69
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
