Hardware for installing a Radium Engineering fuel filter in the MK5 Supra. The upper half of the billet aluminum clamp secures to OEM threaded studs using the provided flange nuts. These studs are on the opposing side of the plastic undertray just to the left of the transmission.
The lower half of the billet aluminum clamp secures the filter using stainless steel bolts.
The picture above shows the and (both sold separately).
FEATURES
-Mounts to OEM Threaded Studs
-No Permanent Modifications Required
-Billet Anodized Aluminum Clamps
-Clamp Diameter: 60mm (2.36")
-Stainless Steel Bolts
NOTES
1. The filter is not included in the mount kit, but can be selected above.
2. For information on Radium fuel filters, please see
3. Aftermarket fuel lines and fittings will need to be configured separately.
4. This clamp will also work with an external fuel pump.
The lower half of the billet aluminum clamp secures the filter using stainless steel bolts.
The picture above shows the and (both sold separately).
FEATURES
-Mounts to OEM Threaded Studs
-No Permanent Modifications Required
-Billet Anodized Aluminum Clamps
-Clamp Diameter: 60mm (2.36")
-Stainless Steel Bolts
NOTES
1. The filter is not included in the mount kit, but can be selected above.
2. For information on Radium fuel filters, please see
3. Aftermarket fuel lines and fittings will need to be configured separately.
4. This clamp will also work with an external fuel pump.
USD : 29.98
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
