MSD Spark Plug Wires Fits 1990-2000 Mazda Miata - 1.6L & 1.8L Engines - 32599
Fitments:
1990-2000 Mazda Miata (1.6L, 1.8L Engines)
Features:
8.5MM Wires
40 - 50 Ohms of Resistance
Adjustable Multi-Angle Plug Boot
Helically Wound Wire
Red Wires & Grey Boots
4 Piece set
Let IPG Parts be your one stop shop for all your Performance Parts Needs !!
MSD's 8.5mm Super Conductor wire sets have a special helically wound core that has just 40-50 ohms of resistance per foot--but with an RFI suppression equal to a 1,500 ohm wire. In fact, each foot of finished wire features 40 ft. of tightly wound copper for superior conductivity. This winding procedure, combined with a ferro-magnetic impregnated center core, produces an extremely effective Electro Magnetic Interference "choke". This choke, or suppression capability, keeps the EMI inside the wire where it cannot interfere with other electronics on your vehicle. A tough, 8.5mm synthetic/silicone jacket over an extra-heavy glass braid and dielectric insulator keeps the current guided to the plugs. Underneath the high-temperature boots, dual crimp stainless steel terminals feature snap-locks to ensure a secure fit.
Fitments:
1990-2000 Mazda Miata (1.6L, 1.8L Engines)
Features:
8.5MM Wires
40 - 50 Ohms of Resistance
Adjustable Multi-Angle Plug Boot
Helically Wound Wire
Red Wires & Grey Boots
4 Piece set
Let IPG Parts be your one stop shop for all your Performance Parts Needs !!
MSD's 8.5mm Super Conductor wire sets have a special helically wound core that has just 40-50 ohms of resistance per foot--but with an RFI suppression equal to a 1,500 ohm wire. In fact, each foot of finished wire features 40 ft. of tightly wound copper for superior conductivity. This winding procedure, combined with a ferro-magnetic impregnated center core, produces an extremely effective Electro Magnetic Interference "choke". This choke, or suppression capability, keeps the EMI inside the wire where it cannot interfere with other electronics on your vehicle. A tough, 8.5mm synthetic/silicone jacket over an extra-heavy glass braid and dielectric insulator keeps the current guided to the plugs. Underneath the high-temperature boots, dual crimp stainless steel terminals feature snap-locks to ensure a secure fit.
USD : 39.58
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
